Micro-Macinazione SA - The european micronization leader for pharmaceutical industry

Technical description

The new double screw electric feeder TECHPROŽ 50 is used for the feeding of pharmaceutical, chemical, cosmetic powders with a difficult rate of sliding. It is complete with an internal four arms agitator.

It is fit for low rates and is recommended for feeding of fine granulometric (below 700 ľm).

It is easy to use and to clean. Parts in contact with powder are in AISI 316L mirror polished.

Driven by a.c. motor with speed adjustment through a frequecy variator.

The motor is coupled with a gear reducer.

The feeder is fit with adjusting speed potentiometer and ON-OFF switch.

The control switchboard includes also the inverter.

The feeder hopper (volume 0,6L) is easy to disassemble and it is fit with cover safety-protection net and closing-knob.

Upon request, a special pre-hopper of 4,5 liter in AISI 316L can be installed.

Feeder Technical Features
Dimensions (LxBxH)	460 x 150 x 200 mm
Electric supply	3x230 / 400V-50Hz
Motor rating	51W 3x230 / 400V-50Hz IP 55
Protection rate	IP 55
Weight	7 kg
Feed Rate	50 ÷ 1000 gr/h (about powders)
Screws feeder	Standard type A with concave profile (0,32 cm3/turn) in AISI 316L (upon request other 3 special profiles)
Standard hopper	0,6 L with protection net
Agitator	4 special profile blades
Material	AISI 316L mirror polished 320 GRIT

<< back